STEP #1
Drill 2 holes in the flat discs that are to be embellished.
STEP #2
Cut linen 6 to 8 inches the same amount of holes drilled
STEP #3
Design and set up the pattern of beads to be used and plan the look of the bracelet
STEP #4
Tie the beads on the discs leaving the ends either to the front or hidden on the backside
STEP #5 – Alternative idea
If making the copper discs, cut the copper in small circles. Place copper circles into the concave holes on a dapping block. Hammer with a ball ping hammer to shape and harden. Using an awl and hammer, punch a hole into the bottom of the circle. These can now be used to embellish.
|